Construction and application process of Renault pad
Published:
2021-05-19
Renault pad assembly requirements Arrange in a flat and strong place. When opening the operation selection place, please pay attention to the need to facilitate the assembly and transportation of Renault pad and not affect the implementation of other operations on site. Renault pad opens the cage and opens the Renault pad packed in bundles. Take out a intact Renault pad, disassemble it and step on it to proofread the zigzag deformation
The assembly of Reynolds pads needs to be arranged on a flat and firm place to open the operation. When choosing a place, please pay attention to the need to facilitate the assembly and handling of Reynolds pads, and not affect the execution of other operations on site. Reynolds pads open the cage 1. Open the bundled Renault pads, take out a complete Renault pad, disassemble it and step on it, and check the bent and deformed ones.
Renault pad construction process The equipment difference between the packed Renault pad, single partition and double partition of Renault pad is mainly in the partition disposal process during assembly, and the other processes are the same. The single partition assembly process: erect the partition and For the front and rear panels, fix the corners of the Reynolds pad with the edge steel wire extensions, on the same horizontal line as the upper edge of the Reynolds pad, and all vertical partitions and panels should be vertical to the ground.
Open the Reynolds pad. For example, the 6m long standard Reynolds pad has 5 double partitions. When the other partitions were packaged at the factory, they used to be half the height of the partitions. You only need to stand up the partitions on site and flip them up. For side panels, fix the partitions and side panels by dot tying, with a total of 14 places, and because the partitions are available from the extension of the marginal steel wire, only one point is twisted at each place; two points are twisted at each place for double partitions, because The Renault pad in the turning section can be socketed by cutting the Renault pad unit.
The above is the introduction about the construction process of Renault pads, I hope it can help everyone. Hebei Golden Coast Road and Bridge Engineering Co., Ltd. is a professional manufacturer of Renault pads. While providing high-quality products, it is more important to provide a safe, economical and ecological new engineering structure for the majority of owners, design and construction units. solution.
key word:
Renault pad
Related news
2022-12-13
Online Message
Quick Nav
Contact Us
Address: No. A7-02, Huafu Street, Raoyang Economic Development Zone, Hebei Province
Tel: 18831889815 (Manager Xu)
Web: www.gebin1688.cn
Mail: 772458770@qq.com